PROMOTING TECHNOLOGY THROUGH INSPIRATION AND INNOVATION
Agragami Applied Aeronautics, first time in India, is offering internship & training program for different varieties of Unmanned Aerial Vehicle(UAV) construction which are operated by Ground Control Station(GCS). We provide six acre campus fully dedicated for aerospace facility, which include an AVRO-748 (turbo prop), DEVON (piston engine powered), SCHWIZER (helicopter),
hanger facility for maintenance, control system and avionics lab etc. The students, undergo these programs will have an opportunity not only for theoretical and practical knowledge about UAV but also they will have actual interaction with the real aircrafts and facilities available in the campus.
The internship & training program will be carried out as follows.
|DAY||MORNING SESSION||AFTERNOON SESSION|
|1st day||Basic theory||Real aircraft interaction|
|2nd day||UAV construction||UAV construction|
|3rd day||UAV construction||UAV construction|
|4th day||UAV construction||Test flight|
|5th day||Simulator introduction||Certificate distribution|
|NAME OF TRAINING & INTERNSHIP||DURATION||COST(IN RUPEES)|
|Foam UAV CONSTRUCTION||5 days||3000+material charge|
|Wooden UAV CONSTRUCTION||5 days||6000+material charge|
|Composite UAV CONSTRUCTION||5 days||10,000+material charge|
Multi-copter are best to known as VTOL rotor crafts which have more than one rotor compare to normal helicopter, usually suitable for both Indore and outdoor flying. These are very famous for aerial photography and cinematography carrying on-board camera and pan tilt to capture the best aerial photos and videos. So if you really want to experience the flying and to learn the construction of multi copters then it's time to take a workshop in multi-copter.
These crafts have very wonderful experience in the field of aerial surveillance ,disaster management , geological mapping , forest monitoring ,wild life photography , urban planning , real-estate, documentary move making etc .Now a day's many universities are working on fully autonomous quad copter as using swarm technology distributing the work between a bunch of flying machines which perform the mission by sharing their information in between them, even very complex man oeuvres are, carried by leaser optics, used for signal processing or transfer of the commands to the flying machines. There are various levels of vehicle system designs.
The main part of the workshop is to give the student a hands on experience of flight controller, flight software, controlling multiple motors at a time , 3-axies gyroscope , accelerometer , magnetometer, installing flight algorithm , stick calibration , tuning the vehicle, installation of receiver, installing power channel connection, flight mode setups, distribution board & power harnessing wires.
The students are going to assemble the aero frame of the copter and install the entire electronics component in the air frame including the flight controller. So it will help them to understand sophisticated unmanned flying vehicles. It will give them a very good exposure to unmanned industry.
|One||Basics of Multi rotor flight|
|Two||Calculations and initial designing|
|Three||Vehicle Designing & Assembly|
|Four||Vehicle Flying Test|
|Five||Introduction To Flying Training|
|MULTICOPTER||5 Days||On Campus & Off Campus ( In The Respective College)||
(Including full kit)
|HEX-COPTER & Y-6 DESIGN||5 Days||On Campus & Off Campus ( In The Respective College)||
|TRI-COPTER||5 Days||On Campus & Off Campus ( In The Respective College)||